Warranty; Technical Specifications - Gymform DUAL SHAPER Bedienungsanleitung

ALTA_MANUAL 8 IDIOMAS GF DUAL SHAPER.pdf
- If you want to change the EMS level or programme while using the belt
on the EMS and vibration settings at the same time, remove the panel from
the fastener before doing so. This way, you will avoid the risk of increasing
the EMS intensity several levels at once.
ATTENTION: WE RECOMMEND REPLACING THE ELECTRODES
AFTER EVERY 30 USES. IF YOU NOTICE THE ELECTRODES HAVE
PREMATURELY LOST THEIR ADHESIVE POWER, WET THEM WITH A
DAMP SPONGE.
Use only the electrodes supplied by the distributor of Gymform Dual Shaper.
The electrodes supplied with Gymform Dual Shaper require no disinfection
or sterilization.
The duration of each programme is set by default. However, if you want
the programme to finish sooner, you can turn off the EMS option by pressing
the ON/OFF button until you reach Programme 0.
Follow these steps:
C
- Press the ON/OFF button on the EMS screen once to activate the option.
Programme 0 will appear on the screen. Then press the ON/OFF button
M
as many times as necessary until you select the desired programme from
1 to 5.
Y
- Press the + and - intensity buttons to select the intensity of the EMS
signal. Level 1 is the lowest intensity level and level 30 is the highest. It is
CM
best to increase intensity gradually to keep the EMS signal from becoming
uncomfortable.
MY
CLEANING AND MAINTENANCE
CY Your GYMFORM DUAL SHAPER belt requires virtually no cleaning or
®
maintenance. However, if your GYMFORM® DUAL SHAPER belt requires
any cleaning, use only a soft damp cloth. Make sure the device is unplugged
CMY
from the mains before cleaning.
K

WARRANTY

This product is covered by a warranty against manufacturing defects subject
to the time periods stipulated by the legislation in force in each country.
DISPOSAL
To protect the environment, if you decide to dispose of this device, the
battery or the current adapter, use special containers for electrical and
electronic devices.
CERTIFICATES AND STANDARDS
This product complies with Directives 73/23/EEC (Low Voltage) and
89/336/EEC (Electromagnetic Compatibility) for household use.

TECHNICAL SPECIFICATIONS

Power supply of GYMFORM® DUAL SHAPER by means of the adapter
supplied, model SW1201000-W02:
5 06/04/11 13:03
Input voltage: 100-240V 50/60 Hz 0.65A; Output: 12V 1.0A
Load range: 300 ohm – 5000 ohm
Signal Characteristics in Relation to Electrode Connection
Programme
1
2
3
4
5
Changes in load impedance within the device's operating range may
produce current and voltage changes in relation to the load impedance.
ATTENTION
DISPOSING OF MATERIALS
The symbol of a crossed out rubbish bin with wheels indicates
that you must be aware of and follow local regulations with regard
to the disposal of this kind of product.
Do not dispose of this product the way you would dispose of normal
household waste.
You must follow the relevant local regulations.
Electric and electronic products contain hazardous substances that have
harmful effects on the environment and human health and should be
recycled properly.
Industex, S.L.
Av. P. Catalanes, 34, 8ª planta
08950 Esplugas de Llobregat
Barcelona-SPAIN
Made in China
Pulse Width µS Frequency Hz:
min-max
460 4 - 18
460 10 - 15
460 4 - 30
460 0 - 35
460 4 - 25
Intensity mA:
min -max
1.8 - 42.0
2.3 - 42.0
2.0 - 42.0
2.5 - 42.0
1.5 - 42.0
5