Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Handling
• When setting up the product, make sure that the cables are neither kinked nor
pinched.
• The device must only be used in dry indoor areas. The product must not get damp
or wet! Danger of a lethal electric shock!
• Avoid the following unfavourable environmental conditions at the installation loca-
tion and during transportation:
- Damp or excess air humidity
- Extreme cold (<0°C) or heat (>45°C), direct sunlight,
- Dust or flammable gases, fumes or solvents
- Strong vibrations, impacts or blows,
- Strong magnetic fields such as those found close to machinery or loud-
speakers
• Never use the product immediately after it has been taken from a cold room to a
warm one. The condensation that forms might destroy your unit. In addition, there
is a risk of a fatal electric shock.
Allow the product to reach room temperature, before connecting it to the power
supply and putting it in to use. This may take several hours.
• Ensure that the insulation for the entire product is neither damaged nor destroyed.
• Check the product for damage before each use!
If you detect any damage, DO NOT connect the product to the mains supply! This
presents a danger to life!
• It can be assumed that safe operation is no longer possible if
- the device shows visible signs of damage,
- the device does not operate any longer and
- if the device was stored under adverse conditions for a long period of time or
- it has been subjected to considerable stress in transit.
• Any service or repair work must only be carried out by authorised personnel.
Maintenance and Cleaning
The product does not require any maintenance and should never be disassembled for any rea-
son.
Use a clean, dry soft cloth for cleaning. Do not use any aggressive cleaning agents as these may
result in discolouration of the enclosure.
Disposal
When disposing of an unserviceable product, do so in line with the relevant statu-
tory regulations.
Declaration of Conformity (DOC)
We, Conrad Electronic, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare that this
product conforms to the fundamental requirements and the other relevant regulations of the
directive 1999/5/EG.
You can find the declaration of conformity for this product at www.conrad.com.
Technical Data
a) Print server
Network:................................10/100MBit
WLAN: ..................................802.11b/g, max. 54MBit
USB port: ..............................1x USB2.0/1.1
b) Wall plug transformer
Operating voltage..................100-240V~, 50/60Hz
Output ..................................5V=, 1A
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240
Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or
the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2009 by Conrad Electronic SE.
Werbung
Inhaltsverzeichnis
