Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Quick Reference USB=PS/2 Converter
The HAMA USB-PS/2 Converter is perfect for using devices with PS/2-ports in a USB
environment. With this converter you can use two devices (Mouse and keyboard) with PS/2-port
at the USB-Port. The converter is also ideal for mobile computers. The power supply is done via
the USB-port (Bus powered). The total power consumption of both PS/2 devices must not
exceed
important instructions: During the installation the keyboard and/or the mouse must be
connected to the
The keyboard and mouse connected to the USB-PS/2 Converter are only functioning after
loading Windows and the USB-support. Therefore the devices are also in DOS mode and in
Windows the mouse in ,,Safe mode" not functioning,
Installation
Only
Windows 98 gives you full
devices. Moreover
when installing
Therefore we only describe the Installation using Windows 98:
connecting the converter to the USB-port there appears a window ,,New Hardware Found"
After
and the converter is identified as ,,USB=PS/2 Active Adapter". Shortly after this the system
opens the Add New Hardware Wizard and searches for new drivers for "USB Human Interface
Device". Please click on 3 Next,
In the following window (,,What do you want Windows to do?") click on ,,Display a list of all the
drivers in a specific location, so you can select the driver you want." 3 Next.
Please click on ,,Show compatible hardware" and then on "USB Human Interface Device" 3
Next 2 Next.
Now the system screen shows the advice to insert the Windows 98 CD-ROM. Please follow the
advice and then click on ,,Ok" (Possibly you must enter another drive letter for your CD-ROM
drive).
Windows 98 now installs the necessary drivers from the CD. Now please click on ,,Finish".
Then the computer detects a second Human Interface Device and the above described
installation is done again.
You can now check, if the Converter has been installed properly. Click on Start j Settings 3
Control Panel z System = Device Manager a "Human Interface Devices". There must be
an entry "USB Human Interface Device" without a yellow exclamation mark.
Hardware installing: Now you can connect the keyboard and/or the mouse to the USB-PS/2
converter. They are working immediately.
Wake-Up key: If your system doesn't awake from the Sleep-, Power-Down or Energy save mode
when you move the mouse or hit a key on the keyboard, please press this key.
computer and not at the USB-PS/2 Converter!
USB-support. Windows 95 B (OSR2.1) with installed USB-Support
only a few USB-drivers
have been optimized for Windows 95.
Werbung
