Werbung
Verfügbare Sprachen
Verfügbare Sprachen
USER MANUAL
Thank you for purchasing this speaker stand, which is used to install
loudspeakers with standard mounting flange (Ø35 mm). The stand is adjustable
in height and designed for even load distribution of up to 50 kg. The stand is
intended for professional use, e.g. on stages, in discotheques, theaters etc.
Please read these operating instructions carefully before using the product. They
contain important information for the correct use of your product. Please keep
them for future reference.
FEATURES
Stable steel version
Height adjustable, with locking pin
Height: 92-140 cm
Tube diameter: Ø35 mm
Centric load: 50 kg
Scratch-resistant black finish
SAFETY INSTRUCTIONS
Only use the product according to the instructions given herein. Damages due
to failure to follow these operating instructions will void the warranty! We do not
assume any liability for any resulting damage.
We do not assume any liability for material and personal damage caused by
improper use or non-compliance with the safety instructions. In such cases,
the warranty/guarantee will be null and void.
Unauthorized rebuilds or modifications of the product are not permitted for
reasons of safety and render the warranty invalid.
This product is not a toy. Keep it out of the reach of children. Do not leave
packaging material lying around carelessly.
Unauthorized rebuilds or modifications of the product are not permitted for
reasons of safety and render the warranty invalid.
This product is intended for indoor use only. Using it outdoors could lead to
product failure and personal injury.
Never exceed the maximum load of the stand. In case of overload, the stand
may tip over and cause injuries and property damage.
The stand must always be set up on firm and even ground (max. inclination 5°)
capable of supporting the weight of both the stand and the load. When the
stand is installed on soft or uneven ground, the stand may tip over and cause
injuries and property damage.
If a loaded stand with raised column is moved, the stand may tip over and
cause injuries and property damage. Remove installed devices and lower the
column before moving the stand.
The installer is responsible for adhering to the carrying capacity given by the
manufacturer, the safety requirements and the qualification of possible co-
workers. Make sure that the installation complies with the standards and rules
that apply in your country.
After installation, this product requires inspections periodically to prevent the
possibility of rot, deformation and looseness.
Before taking into operation, check upon possible damages. If defective, the
stand must not be taken into operation.
This product is maintenance-free, except for occasional cleaning. You can use
a slightly dampened cloth for cleaning.
Comply with all applicable disposal laws in your country.
Should you have further questions, please contact your dealer.
© 2018 Omnitronic. All rights reserved • Omnitronic is a brand of Steinigke Showtechnic GmbH • Andreas-Bauer-Str. 5 • 97297 Waldbüttelbrunn, Germany
BS-1 EU
SPEAKER STAND
USE
5
Pull out the legs – Loosen the safety screw (1) of the legs. Pull out the legs (2).
Lock this position with the safety screw.
Loading - Attach the loudspeaker on the top end of the stand (3).
Height adjustment - Loosen the safety screw of the extension tube (4) and pull it
out to the desired height. Insert the locking pin (5) to secure the height
adjustment. Tighten the safety screw again.
Disassembly - Disassembly is effected in reverse order.
TECHNICAL SPECIFICATIONS
Item number:
60004160
Max. carrying capacity:
50 kg
Adjustable height:
92-140 cm
Ø tubes:
38/35 mm
Material:
Steel
Transport dimensions:
77 x 11 cm
Weight:
3.1 kg
Subject to change.
www.omnitronic.de
3
4
1
2
Werbung
