Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Instruction Manual
With the voltage distributor you can have another 12 V socket, e.g.
for the charger of your mobile phone. The connector can be tilted in
seven steps (angle 0 to 180°) and can be used with most vehicles.
Please Notice! Don't use with 24 V power systems!
Installation
Insert the voltage distributor into
the cigarette lighter socket of
your car. When the function
2 Consumers max. 10 A
total
control LED on the distributor
lights up, the distributor is ready
to use. If the led does not light
up,
check
the
fuse
(see
Control LED
Changing / Checking the fuse).
Tilt the distributor to the desired
position and connect the desired
Fuse in the
consumers.
Tip
Changing / Checking the Fuse
Unscrew the front of the distributor (turn counter clockwise) and
remove the internal fuse.
Check the fuse. If it is defective, replace it with one of the same type
(10 A).
Please Notice!
Do not expose to loads exceeding 10 A (or 120 W). If the starter
battery is weak, disconnect the distributor from the vehicle power
system to disconnect unnecessary consumers.
IV
Werbung
