Unitec Turbo Gebrauchsanweisung Seite 3

User instructions

IMPoRTANT: Please read these instructions carefully. observe the requirements
for safe operation and the warning and safety instructions. Use this product
only for its intended purpose. Failure to observe these instructions may lead to
damage or personal injury and to the lapse of the guarantee. Please retain these
user instructions during the life of the product and pass them on to other users
or any subsequent owner of the product.
• Short heating up time thanks to original equipment manufacturer technology
(carbon heating pad)
• Generous heating area
• two heat settings that can be distinguished even in the dark thanks to
different-coloured LeDs
• Suitable for use with side airbag thanks to special fixing system
• High-quality wide fixing straps for optimum sitting position
• Comfortable mesh material
• 12 V connection suitable for in-vehicle sockets and cigarette lighter sockets
• Makes you feel good with its heated back and seat areas
• Fits all the usual car seats.
• Only use with a 12V (car) connection
• Do not fold or bend the seat heating
• Pull out the plug when leaving the car
• Do not stick any pins or needles in it
• never use it unattended
• Do not use it if it is wet
• Do not wash or dry clean it
• Do not exceed maximum heating period of 1 hour
• Do not use it with people in need of assistance,
babies or toddlers or people sensitive to heat.
• the seat cover is to be checked to ensure its correct
fixing and position every time you get in or out of
the vehicle. If the seat cover is out of place, please
adjust it
• not suitable for sports seats or seats with built-in
headrests.
• "Low" indicated by yellow LeD,
reaches a maximum of about 34°C after 5 mins.
• "High" indicated by a red LeD,
reaches a maximum of about 38°C after 5 mins.
• 12 Volt
• 3.6-4.4 A (3.6 A with "Low" setting /
4.4 A with "High" setting)
• 43-53 W (43 W with "Low" setting /
53 W with "High" setting)
Do not dispose of this product with the
domestic refuse but at the points set up for
taking back old electrical devices.
75772_Bed_120515.indd 3
Safety instructions
low
Heat settings
Technical data
Disposal instructions
high
3
05.06.12 09:33