Safety Instructions - Inakustik 00315002 Bedienungsanleitung

SAFETY INSTRUCTIONS

1. General
Read, observe and adhere to the following safety instructions. Please keep the operating manual. Observe all the warning notices on the
components and in the operating manual.
2. Proper use
The components are solely designed for operation indoors. Connect them as specified in the operating instructions. Only use accessories which
have been recommended by the manufacturer.
3. Humidity
Select an installation location for the components which does not have a high level of relative humidity and is free of moisture. Never use the
components near water. Moisture can bypass the electrical insulation and pose a lethal danger, as it can for all products not specially designed
to be water-resistant. The components may not be exposed to dripping or sprayed water.
4. Product protection
Do not under any circumstances expose the components to high levels of humidity. Extreme temperature fluctuations, humidity and extended
exposure to light can damage the components and alter their appearance. Make sure that no foreign objects or liquids enter the components.
5. Positioning
Do not position the components near sources of heat, heaters, heating valves, ovens or other heat-producing devices. The components may
only be stored and operated in the temperature range stated. The components heat up during operation.
6. Connection
The components must only be connected to the specified rated voltage!
All cables must be positioned in such a way that there is no danger of them being damaged (e.g. being stepped on, placed under furniture
etc.). Never remove cables by pulling the cable; instead, always hold the plug when disconnecting.
In stand-by mode, the components are not completely disconnected from the mains supply. To avoid any unnecessary hazards or energy
consumption during longer absences, the components should be disconnected from the mains supply.
7. Maintenance
Maintenance on the product may only be performed by persons qualified to do so. Maintenance is necessary in all cases of damage, i.e. in the
case of damaged cables and plugs, as well as after liquid spills or objects falling on the components, components falling down, foreign bodies
entering the components, exposure of components to rain or humidity, or other influences impairing the functioning of the components.
8.Looking after the product
Disconnect the components from the power supply before cleaning them Always clean the components with a soft, dry and lint-free cloth, or
with a brush. Do not under any circumstances use scouring powder, alcohol, benzine, furniture polish or similar substances.
Dear customers,
Thanks for purchasing TOSLINK /SPDIF to Audio RL converter box, before you connection, please read this instruction manual for guidelines,
and it is recommended to keep this for further information.
1.0 INTRODUCTION
Please check the contents before you begin with the installation.
 Star Audio D/A Converter | USB
 USB power supply unit
 USB  DC cable
1.1 FEATURES
 Supports audio formats LPCM 44/48/96 kHz
 Supports up to 24 bits
 LED Indication
 Weight: 43 g/71 g (converter / power supply)
1.2 OUTPUT AND CONNECTIONS
TOSLINK COAX
User Manual
R-Audio-L TOSLINK/SPDIF
switch
DC Jack