Sundirect IC-Series Installationsanleitung

INSTALLATION MANUAL
Sundirect Infrared panel heaters
Mounting installation manual for IC/GD/MD/RC series
Note: The centre of the mounting bracket will be the centre point of the panel when mounted (note, the mounting
fixings on the rear of the panel are offset, so measure from the centre of the panel to the edge of the panel to
determine the mounting position).
For vertical mounting "A" will be the top of the mounting bracket.
For horizontal mounting "B" will be the top of the mounting bracket.
The kit supplied in the package is designed for the mounting on a solid wall/ceiling. If mounted onto other types of
wall, you will need appropriate fixings (not supplied). Please make sure the wall is safe to mount. If mount to the
ceiling, it's extremely important that the panel is locked in the secure position. We highly recommend to have the
panel installed by a qualified electrician or installer authorized by Sundirect.
Please be noticed that GD/MD series and RC350-M are designed only for wall mounting.
1
3
5
Sundirect Technology Ltd.
info@sundirect-heater.com
www.sundirect-heater.com
2
WALL
4
WALL
6
WALL
WALL
Step1. Use the supplied mounting bracket to
mark the position of the holes on the wall.
Step2. Drill holes using a 8mm drill.
Step3. Insert the dowels into the holes.
WALL
Step4. Screw the screws into the dowels
through the holes on the mounting bracket.
Step5. Mount the panel on the mounting
bracket.
Step6. Move the panel into two directions to
make sure the panel is secured.
WALL
Sundirect and the Sundirect Logo are registered Trademarks of Sundirect Technology Ltd.
© Sundirect Technology Ltd. All rights reserved.