Conrad 87 93 19 Bedienungsanleitung Seite 3

O P E R A T I N G I N S T R U C T I O N S
Steering wheel for Internet
tablets and iPad
Item no. 87 93 19
Intended use
The product can be inserted into an Internet tablet or an Apple® iPad. The special design and
the integrated panning/inclination function of the wheel enable easier control of many racing
and fl ying games.
Furthermore, the product features integrated loudspeakers which can be connected to the
tablet computer via Bluetooth.
The power is supplied via batteries (or alternatively, via an external USB power supply unit, not
included in the delivery, to be ordered separately).
This product complies with the applicable national and European requirements. All names of
companies and products are the trademarks of the respective owner. All rights reserved.
Package Contents
• Wheel
• Supporting stand with integrated loudspeakers
• USB-Y cable
• 4 batteries AA/Mignon
• Operating instructions
• Manufacturer's operation instructions (in English)
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe
these safety instructions! We do not assume any liability for any consequen-
tial damage!
We shall not accept liability for damage to property or personal injury caused
by incorrect handling or non-compliance with the safety instructions! In such
cases, the warranty will be null and void.
• The unauthorised conversion and/or modifi cation of the product is not permitted for
safety and approval reasons (CE).
• The product is not a toy and should be kept out of the reach of children.
• The product is only intended for use in dry, indoor locations. No part of the product
must be allowed to get damp or wet. Protect the product from extreme tempera-
tures and direct sunlight.
• Do not leave packaging material carelessly lying around, since it could become a
dangerous plaything for children.
• Handle the product with care, it can be damaged by impacts, blows, or accidental
falls, even from a low height.
General information on batteries/rechargeable batteries
• Batteries/rechargeable batteries must be kept out of the reach of children.
• Do not leave batteries/rechargeable batteries lying around; they could be swallowed by chil-
dren or pets. If they are swallowed, consult a doctor immediately.
• Leaking, or damaged batteries/rechargeable batteries, in contact with the skin can cause
acid burns, therefore, use suitable protective gloves.
• Batteries/rechargeable batteries must not be short-circuited, opened or thrown into a fi re.
There is a risk of explosion!
• Do not recharge normal, non-rechargeable batteries, risk of explosion! Only charge re-
chargeable batteries that are intended for this purpose; use a suitable battery charger.
• Never mix standard batteries with rechargeable batteries, use either standard batteries or
rechargeable batteries.
• Do not mix batteries/rechargeable batteries with different charge levels (e. g. full and half-full
batteries/rechargeable batteries).
• Always replace the complete set of batteries/rechargeable batteries.
• Check that the polarity is correct when inserting the batteries/rechargeable batteries (pay attention to
plus and minus).
• If you wish to use rechargeable batteries please note that, due to the lower output voltage
(batteries = 1.5 V, rechargeable batteries =1.2 V), the operating time will decrease.
Therefore, we recommend that you use high-quality alkaline batteries to ensure long-lasting
and reliable operation. Alternatively, the product can be operated via a USB power supply unit
(output current min. 1 A).
Getting Started
www.conrad.com
a) Assembly
☞
Version 11/12
Place the wheel on the supporting stand. Press and hold the lock knob and push the fi xture
of the supporting stand at bottom into the slot of the wheel until the wheel clicks in place. Pay
attention to the correct orientation; see imprint on the square retaining plate on the supporting
stand.
You can set how easily the steering wheel can be moved by slightly loosening or tightening the
orange retaining ring.
b) Inserting or removing the table computer
• Press the locking lever on the side. The integrated spring causes the two wide clamping
holders to snap out to the maximum height.
• The height of the fastening clamp in the clamping holder can be adjusted to the tablet com-
puter used by means of the two round screw knobs.
First move the screw knobs entirely to the left turning them anticlockwise so that the fastening
clamps are fully opened.
• Insert the table computer so that it is located in the middle of the steering wheel and push the
clamping holders together. An internal detent prevents the clamping holders from coming off
by themselves.
• In a fi nal step turn the two screw heads in clockwise direction until the tablet computer is
securely fastened by the fastening clamps. However, do not use any force.
c) Power supply
If you want to operate the product with batteries, open the battery compartment on the bottom
and insert 4 batteries, type AA/Mignon, paying attention to the correct polarity (plus/+ and
minus/-). Close the battery compartment again. Move the sliding switch on the back side to the
corresponding position (push in direction of battery symbol).
• For operation via an external power supply the sliding switch on the back side has to be
moved to the corresponding position (push in direction of USB symbol). Use the USB-Y cable
provided for this. The external power supply (e. g. a USB power supply unit) must provide a
current of at least 1 A.
d) Mounting location
• Place the device on a level, stable and smooth surface. Protect valuable furniture surfaces by
using a suitable mat to prevent scratches or pressure points.
• During operation place the product in a safe way that secures it from falling. Place it so that
the keys at the bottom in the supporting stand are facing you.
e) Switching on/off
• Briefl y press the " " button to switch the product on.
• Turn off the product by pressing the " " button for 2 seconds, until the upper power LED
goes out.
f) Pairing
• First turn the steering wheel on (briefl y press the " " button). Now the blue "BT" LED should
fl ash.
• Activate the Bluetooth function of your tablet computer (in an iPad this function can be found
in the "Settings" menu under "General").
• Wait until the tablet computer has recognised the wheel (e.g. "Cideko Racer") and then select
this device.
Observe the illustrations in the manufacturer's operating instructions.
To remove the tablet computer, loosen the fastening clamps again, turn the two
screw heads anticlockwise.
Hold the tablet computer to prevent it from falling out.
Afterwards, press the locking lever on the side so that the clamping holders are
unfastened. Pull out the tablet computer from the steering wheel.
During operation, the power LED will start to fl ash if the battery voltage drops
(< 4.0 V). If the battery voltage is too low, the product switches off automatically.
If you want to use a PC or a USB hub with separate power supply unit to provide
the current, you have to use both USB-A plugs of the USB-Y cable enclosed. Thus,
the current is added up by 500 mA per USB port (500 mA + 500 mA = 1 A) and the
operation of the product is ensured.
Should you be prompted to enter a password or Pin Code, enter "0000" (four times
the fi gure "0").