Charge Battery; Core Functions; Microsd Card - RC Logger RC EYE OneCam 5.8 GHz RX Bedienungsanleitung

Charge battery

For proper charging, a power adapter with USB connection
is required. The required voltage and current are as follows:
5 v/dC, min. 2 a
1. Make sure the monitor is turned off. See chapter "Core
functions" on page 12 to learn more.
2. Connect the mini-B connector of the USB cable to the mini
USB socket (17) on the monitor.
3. Connect the A-plug to your power adapter.
4. Establish the power connection.
5. After a charging duration of 4 – 6 hours the battery is fully
charged.
6. Disconnet the USB cable from the monitor.
12

11. Core funCTIons

Turn on and off
> Press and hold button m (2) for approx. 3 seconds to turn
the monitor on.
> Press and hold button m (2) for approx. 3 seconds to turn
the monitor off.

microsd card

> A microSD card is used to store pictures and video
recordings.
> Insert a microSD card (1 to 32 GB) into the microSD card
slot (14). Make sure it looks in place.
> To remove the microSD card, push it in until it unlocks.
Carefully pull it out.
select receiving mode (wired/wireless)
The monitor can operate with cameras connected wirelessly
or by wire. When a camera is connected by wire then the
monitor switches automatically to wired mode. To connect a
wired camera follow the information provided in chapter "Use
monitor as display device" on page 24.