Troubleshooting - NINCOAIR Alumax G 535 Handbuch

Flight control:
Up
Down
Turn left
Turn right
Forward
Backward
Helicopter take off:
The helicopter can take off after trimming.
1. Place the helicopter in the middle of the room over a straight surface.
2. Push the throttle stick up, the rotating speed will increase. Push up quickly before the helicopter takes off the ground.
3. Focus on the helicopter, do not look at the transmitter
4. Practice the up, down and stabilization movements.
Flight process:
5. When the helicopter is flying, turn right and left the right stick: the helicopter turn to right or left over itself.
6. When the helicopter is flying, push and pull the right stick: the helicopter goes forward and backward.
Flight environment:
Fly on a sunny day, without wind:
7. This helicopter is recommended for indoor use (avoid the air conditioned, may affect the flight).
8. Do not fly in extreme temperature. Do not fly in strong wind. Select a large, wide-open area to fly (4m x 5m x 2,5m).
9. Make sure the area is far from people, animals, trees, buildings, high-voltage wire and other obstructions.
TROUBLE SHOOTING
WHAT HAPPENS
The blades do not spin
Suddenly stops and felt down
Lost of control
Push left stick
Pull left stick
Right stick to left
Right stick to right
Push right stick
Pull right stick
CAUSE
- Switch ON / OFF in OFF position
- Battery almost exhausted
- Battery almost exhausted
- Other RC vehicle is using the same frequency.
NINCOAIR is brand of NINCO DESARROLLOS S.L.
Ctra. de l'Hospitalet 32
08940 Cornella Barcelona Spain
CIF B-60307725 · www.nincoair.com
7
SOLUTION
- Switch ON
- Charge the battery
- Charge the battery
- Change the frequency