Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DJ-9500 USB DJ Headphones
Item no. 31 13 39
1.
Intended use
The DJ headphones convert the electric output signals of headphones into acoustic signals (soundwaves).
They are only licensed for connection to USB audio devices.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you use the product
for purposes other than those described above, the product may be damaged. In addition, improper use can
cause hazards such as short circuiting, fire, electric shock etc. Read the instructions carefully and keep them.
Make this product available to third parties only together with its operating instructions.
2.
Delivery content
•
Headphones
•
Cable with remote control
•
Case
•
Operating instructions
3.
Safety instructions
Read the operating instructions carefully and especially observe the safety information. If
you do not follow the safety instructions and information on proper handling in this manual,
we assume no liability for any resulting personal injury or damage to property. Such cases
will invalidate the warranty/guarantee.
Persons / Product
•
Do not listen to excessively loud music over a longer period of time. This may damage your hearing.
•
Use the headphones only when circumstances allow operation. Make sure that the operation of the device
does not impair your concentration on your immediate surroundings.
•
The device is not a toy. Keep it out of the reach of children and pets.
•
Do not leave packaging material lying around carelessly. These may become dangerous playing material
for children.
•
Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity, moisture,
flammable gases, vapours and solvents.
•
Do not place the product under any mechanical stress.
•
If it is no longer possible to operate the product safely, take it out of operation and protect it from any
accidental use. Safe operation can no longer be guaranteed if the product:
-
is visibly damaged,
-
is no longer working properly,
-
has been stored for extended periods in poor ambient conditions or
-
has been subjected to any serious transport-related stresses.
•
Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage the
product.
•
Also observe the safety and operating instructions of any other devices which are connected to the
product.
Miscellaneous
•
Consult an expert when in doubt about operation, safety or connection of the device.
•
Maintenance, modifications and repairs are to be performed exclusively by an expert or at a qualified
shop.
•
If you have questions which remain unanswered by these operating instructions, contact our technical
support service or other technical personnel.
4.
Operation
1.
Plug the cable's stereo jack into the DJ headphones and tighten it by turning it clockwise. Then connect the
USB cable to the audio device.
2.
If the DJ headphones are not automatically recognised by the computer, set them up as an audio output
source in your computer's control panel.
3.
Turn the volume control on the side of the remote control towards "-" and set it to the lowest possible
volume.
4.
Put the headphones on. Use the clip on the back of the remote control to attach it to your clothing.
5.
Turn the headphones on using the power switch on the remote control. Turn the power switch to "on".
6.
Turn the volume control towards "+" until the desired volume level is set.
7.
After use, turn the DJ headphones off with the remote control's power switch. Turn the power switch to "off".
Remove the remote control's clip from your clothing before taking the headphones off.
8.
The additional switch on the side of the remote control has no function with this product.
9.
When the DJ headphones are no longer in use, they can be folded. You can transport them in the case
included in delivery.
5.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product according to the relevant statutory
regulations.
6.
Technical data
Version 11/11
Suitable for:
Frequency range:
Sound pressure:
Impedance:
Load capacity:
Operating voltage:
Current consumption:
Cable length
Weight:
These operating instructions are published by Conrad Electronic SE,
Klaus-Conrad-Straße 1, D-92240 Hirschau/Germany.
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
The operating instructions reflect the current technical specifications at time of print.
© 2011 by Conrad Electronic SE.
Windows® 2000 / XP / Vista™ (32-bit & 64-bit) / 7, (32-bit & 64-bit)
Mac OS 9 or above
20 – 30000 Hz
108 ±3 dB
64 Ω
3500 mW max.
5 V
44 mA max.
approx. 2 m
350 g (incl. cable)
V1_1111_02-JU
Werbung
