Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Using
1. Push down the battery compartment lid of the door bell receiver
in order to have access to the two sliding switches.
2. Slide the ON/OFF switch (12) to the ON position in order to
switch on the receiver.
3. Slide the source selection switch (13) to the IN position, if you
want to use the ringtones that are stored by the factory in the
internal memory of the device.
4. Slide the source selection switch to the SD position, if you want
to play back your individual ringtones (MP3 or WMA format) from
an SD card.
5. Close the battery compartment with the lid.
6. Press the play/stop button (3) or the door bell button (8) on the
transmitter to play back the currently selected ringtone.
7. Press the play/stop button again to stop playing back the ring-
tone.
8. Use the volume + (1) and volume – (4) buttons to select the
desired playback volume for the ringtone.
9. Press the
respectively the previous ringtone/title. The last played title is
stored and used as your ringtone then.
Transfer Ringtones from the Computer to the Door
Bell Receiver
1. Insert an SD card into the SD card slot (10) of the door bell
receiver.
2. Slide the source selection switch (13) to the SD position.
3. Switch on the door bell receiver.
4. Use the supplied mini USB cable (15) to connect the receiver to a
free USB port of your computer.
button (2) or the
Using
button (5) to select the next
12
Werbung
Inhaltsverzeichnis
