Herunterladen Inhalt Inhalt Diese Seite drucken

Installing And Operating Your Fridge Freezer - VESTEL VFKW2176 Betriebsanleitung

No-frost kühl-/gefrierkombination
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

• When removing ice from the ice-making compartment, do not touch it. Ice
may cause frost burns and/or cuts.
• Do not touch frozen goods with wet hands. Do not eat ice-cream or ice
cubes immediately after you have taken them out of the ice-making
compartment.
• Do not re-freeze frozen goods after they have melted. This may cause health
issues such as food poisoning.
• Do not cover the body or top of fridge with lace. This affects the performance of
your fridge.
• Secure any accessories in the fridge during transportation to prevent damage to
the accessories.

Installing and operating your fridge freezer

Before using your fridge freezer, you should pay attention to the following points:
• The operating voltage for your fridge freezer is 220-240 V at 50Hz.
• We do not accept responsibility for any damages that occur due to ungrounded
usage.
• Place your fridge freezer where it will not be exposed to direct sunlight.
• Your appliance should be at least 50 cm away from stoves, gas ovens and heater
cores, and at least 5 cm away from electrical ovens.
• Your fridge freezer should never be used outdoors or exposed to
rain.
• When your fridge freezer is placed next to a deep freezer, there
should be at least 2 cm between them to prevent humidity
forming on the outer surface.
• Do not place anything on your fridge freezer, and install your fridge
freezer in a suitable place so that at least 15 cm of free space is
available above it.
• Do not place heavy items on the appliance.
• Use the adjustable front legs to make sure your appliance is
level and stable. You can adjust the legs by turning them in
either direction. This should be done before placing food in the
fridge freezer.
• Before using your fridge freezer, wipe all parts with a solution of
warm water and a teaspoon of sodium bicarbonate, then rinse
with clean water and dry.
Place all parts in the fridge after cleaning.
• Install the plastic distance guide (the part with black vanes at the rear) by turning it
90° (as shown in the figure) to prevent the condenser from touching the wall.
• The refrigerator should be placed against a wall with a free space not exceeding
75 mm.
EN - 22 -

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis