Connections And Controls - Hughes & Kettner BassKick303 Bedienungsanleitung

BASSKICK-MANUAL

1.0 CONNECTIONS AND CONTROLS

GAIN: Controls the input sensitivity of the BassKick
preamp. Adjust to match your instrument's output
level. Higher gain settings produce punchy rock
sounds.
SOUND MATRIX: Use this rotary knob for
quickly selecting from the different
fundamental sounds.
INPUTS
ACTIVE PASSIVE
ACTIVE INPUT: For basses with
high output levels, such as
instruments with active electronics
or humbucking pickups.
PASSIVE INPUT: For traditional basses
featuring passive pickups and circuitry.
Max. power
consumption
260 VA
50 - 60 Hz
230 V~ T 1 A
100 V~ SB 2500 mA
117 V~ SB 2000 mA
FUSE
PHONES: Plug your headphones into this jack.
Whenever this jack is occupied, the BassKick speaker
output is automatically muted.
MAINS SOCKET: Connect the
included Euro-norm mains cable to
this socket. The fuse holder is
integrated in the socket; use specified
replacement fuses only!
6
MID: Determines to
what extent the
midrange is boosted
or cut.
SOUND MATRIX G A I N
1
2
3
5
OFF
0 10
BASS: This voicing control is
used to define the bottom
end. In center position (12
o'clock) the signal remains
unaffected
CAUTION!
TO PREVENT THE RISK OF FIRE AND SHOCK HAZARD
DON´T EXPOSE THIS APPLIANCE TO MOISTURE OR RAIN.
DO NOT OPEN CASE; NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
SPEAKERS: Use this output to
connect external speakers/cabinets.
Ensure the overall impedance is not
lower than 4 ohms. In other words,
you can connect an additional
cabinet with a minimum
impedance of 8 ohms.
TREBLE: Controls the upper frequencies and
subsequently the crispness and overtone content in
your bass sound. For a warmer sound, this control is
situated right after the input stage in the signal chain. In
other words, it also influences preamp saturation.
B A S S M I D T R E B L E M A S T E R
-5 +5 -5 +5 -5 +5
0
MASTER: Controls the BassKick's stage
volume. The LINE OUT jack signal level is not
affected by this control. The DYNACLIP power
amp circuitry kicks in at higher volume levels,
adding an aggressive edge to your bass tone.
Leave enough space for proper ventilation!
PHONES SPEAKERS
MIN. IMP. 4 Ohms
LINE OUT: Use this
balanced output to send
the signal to a mixing
console or additional
power amp. The signal
routed to this jack is
affected by the EQ section
but not the MASTER
control.
MAINS: AC power switch.
5
1 0 0 W A T T S B A S S A M P L I F I E R
10
MADE IN ST. WENDEL / GERMANY
BALANCED
LINE OUT
FX RETURN:
Connect this
jack to your FX
processor's
OUTPUT jack.
FX SEND: Connect this jack
to the FX processor's INPUT
jack.
MAINS
Ser. No.
FX-LOOP
RETURN SEND