Oral-B ProfessionalCare OxyJet Center Type 3724 Bedienungsanleitung Seite 17

After use
• Rinse your brush head or accessory thoroughly under
running water for several seconds with the handle switched
on.
• Switch off the handle and remove the brush head or
accessory from the handle. Clean both parts separately under
running water, then wipe them dry before you reassemble the
brush and put the handle on the charger base.
Using your irrigator
Before using for the first time, fill the water container
allow the water to run through completely by holding the
irrigator handle r over a washbasin.
1. Attach one of the irrigator jets
into place. Fill the water container with luke warm water
and add mouthwash, if desired.
2. Turn on the irrigator by pressing the on/off switch
When doing so, the handle switch
position = water stop.
3. Select the water pressure with the pressure control dial
(1 = gentle, 5 = strong). We recommend that you start with
setting 1, especially if your gums tend to bleed or if
children are using the irrigator.
4. Bend over a washbasin and guide the jet to your teeth
and gums. Slide the handle switch
stream. Keep your mouth slightly open to allow the water
to run into the washbasin.
You can choose between two different jet functions by sliding
the jet switch down or up (before doing so, turn off the
9
water stream by sliding the handle switch down):
Rotating stream for general cleaning and gum massage (jet
switch in lower position): The rotation of the water stream and
its micro-bubbles is designed for easy penetration.
Mono stream: straight water stream for site-specific cleaning
(jet switch in upper position).
Max. operating time: 15 minutes
Cooling off time: 2 hours
t
to the handle until it locks
8
q
e should be in the lower
up to start the water
e
and
.
w
17