Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Figure 1: Angle- Mount- Cup Installation
Flush Mount Cup
Installation locations: Door Installation (front/rear), rear installation, side view mirror area installation,
•
Insert the tweeter (J) into the flush mount cup (M) and pull the cables through the holes.
•
Stick the threaded bolt (Q) with its M4-side through the flush mount cup (M) and screw it up with the
tweeter (J). (There is a drilling device for the threaded bolt in the magnet bottom of the tweeter).
Tighten the threaded bolt (Q) with a wrench (diameter 7 mm). Caution! Do not tighten too firmly!
•
Attach the spring clip (W) from behind to the threaded bolt (Q) and the flush mount cup (M) and
fasten it with the washer M5 (U) and the hexagon nut M5 (V).
•
Connect the tweeter according to the planned mode of operation active / passive with amplifier or
crossover and adjust the level (see page 16).
Note:
Use only the enclosed threaded bolts for the alternative attachment method. Use of incorrect
or overly long screws can damage the tweeters.
Detaching the protection grill
The protection grill can be detached for optical or sound quality
reasons by a spiky tool. Painting of the protection grill in individual
color is possible.
When putting back the protection grill on the tweeter there is no need
to glue it. The magnetic force of the tweeter's inside neodymium
magnet disc will fix the protection grill to the tweeter.
ATTENTION: Do not damage the tweeter cone with the spiky tool
and do not press into the cone.
instrument panel installation, and rear windshield deck installation
Figure 2: Flush Mount Installation
15
Werbung
Inhaltsverzeichnis
