SmartLab move Bedienungsanleitung Seite 11

V Connecting to App
Before first using the smartLAB® move you need to install an App on your mobile device. You can use the
fitmefit move App or the hLine App, both available for iOS and Android. Insert one of the batteries into your
device. The LEDs will blink for about 10 seconds. Your device is ready for use.
IMPORTANT: The smartLAB® move+ only works with most Samsung and Sony devices with Android 4.3 or
higher, as these support ANT+.
fitmefit
move App
hLine App
Note: Please check our website www.hmm.info for more Apps that will be available in the future.
• The connection of the smartLAB® move is enabled through the App and not through the Bluetooth menu
• Activate the smartLAB® move after installing the App by inserting the battery
• After Batterie exchange you need to reset the time by synchronising the device with the App.
• The serial number is automatically detected by the App. After adding the SN, date and time will be auto-
matically synchronized with the device
• To enable the connection of the to other Apps than the ones mentioned, you might need to start an au-
tomatic or manuall device search
Important information for App use