Operation - Conrad Polarlite 1646407 Bedienungsanleitung

Operating instructions
Solar globe 15 cm
Item no. 1646407
Intended Use
This product is designed for use as an outdoor lamp. It can be used, for example, to illuminate
paths at night in the garden. The light switches on automatically in the dark. Power is provided
via two rechargeable batteries, which charge during the day via a built-in solar panel.
The product is splash-proof and therefore suitable for outdoor use (IP44).
For safety and approval purposes, you must not rebuild and/or modify this product. Using the
product for purposes other than those described above may damage the product. In addition,
improper use can cause hazards such as a short circuit or fire. Read the instructions carefully
and store them in a safe place. Only make this product available to third parties together with
its operating instructions.
This product complies with statutory national and European regulations. All company and
product names are trademarks of their respective owners. All rights reserved.
Delivery Content
• Solar globe with inserted rechargeable battery
• Ground spike
• Operating instructions
Up-to-date operating instructions
Download the latest operating instructions at www.conrad.com/downloads or scan the QR code
shown. Follow the instructions on the website.
Explanation of symbols
The symbol with an exclamation mark in a triangle is used to highlight important
information in these operating instructions. Always read this information carefully.
The arrow symbol indicates special information and advice on how to use the
product.
Safety instructions
Read the operating instructions and safety information carefully. If you do not
follow the safety instructions and information on proper handling in this
manual, we will assume no liability for any resulting personal injury or damage
to property. Such cases will invalidate the warranty/guarantee.
a) General information
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. It may become a
dangerous toy for children.
• Protect the product from extreme temperatures, impacts, flammable gases,
vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, stop using it and prevent
unauthorized use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stress.
• Always handle the product carefully. Jolts, impacts or a fall even from a low height
may damage the product.
• Warning, LED light:
- Do not look directly at the LED light!
- Do not look into the beam directly or with optical instruments!
• Do not short-circuit the battery terminals.
• Consult a technician if you are not sure how to use or connect the product.
• Maintenance, modifications and repairs must be done by a technician or a
specialist repair centre.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
b) Product
• Place the product in a location where nobody can trip over it. Risk of injury!
• The bulb used in the product is permanently installed and cannot be replaced.
• The product generates heat during use. Never cover the product during use.
c) Rechargeable battery
• Ensure that the rechargeable battery is inserted in the correct polarity.
• To prevent battery leakage, remove the battery when you do not plan to use the
product for an extended period. Leaking or damaged batteries may cause acid
burns when they come into contact with skin. Therefore use suitable protective
gloves to handle corrupted rechargeable batteries.
• Keep batteries out of the reach of children. Do not leave batteries lying around, as
they constitute a choking hazard for children and pets.
• Batteries must not be dismantled, short-circuited or thrown into fire. Never
recharge non-rechargeable batteries. Danger of explosion!
Product overview
15 cm
1
2
30.7 cm
3

Operation

Before using for the first time, remove the protective film from the rechargeable battery
compartment. Then fully charge the rechargeable batteries. The charging time is approx.
8 hours in direct sunlight.
• The solar unit with rechargeable battery compartment is located in the bottom of the lamp.
Also see the section "Removing/replacing the rechargeable batteries". Remove the base
cover (2) by unscrewing it counter clockwise from the lamp head (1). The seal on the lamp
head should not be removed.
• Remove the solar unit from the base cover. The rechargeable battery compartment is located
on the back side. Remove the protective battery foil from the battery compartment to ensure
battery contact. Place the solar unit back in the base cover.
• Screw the base cover with the solar unit clockwise into the lamp head. Make sure that the
base cover screws in smoothly and the seal is not crushed.
• Turn the ground spike (3) clockwise into the thread on the base cover.
Setup location
• Insert the ground spike into an even and sufficiently resistant surface (e.g. lawn or bed). A
stony surface can damage the ground spike. Make sure that the ground spike is firm in the
ground and cannot topple over.
• The product must be placed in a location where the lamp head is exposed to direct sunlight
for as long as possible to ensure that the batteries charge properly. Ensure that the lamp is
not covered or shaded.
• Do not place the product next to other light sources, e.g. patio or street lights, as this may
prevent the product from turning on automatically in the dark.
• The product is suitable for use in unprotected outdoor areas. However, the product must
never be used in or under water.
• The light switches on automatically at dusk. As soon as a certain brightness is reached, the
light turns off.
1 Lamp head made of plastic (PMMA)
2 Base cover with solar unit
3 Ground spike