Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
E
PARAMETER FINE button
This button selects the Rev, Pre EQ, and Post EQ pages.
F
UTILITY button
This button selects the Setup, DIO, Meter I/O, and MIDI pages.
G
Motorized faders
These four 60-mm motorized faders are for adjusting parameter values and input and
output levels.
H
INPUT CLIP indicators
There are four INPUT CLIP indicators, one for each channel, which light up when the
corresponding channel's input signal is clipping.
I
OUTPUT CLIP indicators
There are four OUTPUT CLIP indicators, one for each channel, which light up when
the corresponding channel's output signal is clipping.
J
–1/DEC & +1/INC buttons
These buttons work in parallel with the DATA wheel and are used for selecting pro-
grams or projects and setting parameter values. Use the [–1/DEC] button to decrease a
value; the [+1/INC] button to increase it.
K
DATA wheel
This wheel is used for selecting programs or projects and setting parameter values. Turn
it clockwise to increase a value; counterclockwise to decrease it.
L
Cursor buttons (
These buttons are used to maneuver the cursor around the display pages in order to
select buttons and parameters. The left (
right (
) button moves it to the right; the up (
button moves it down.
M
ENTER button
This button is used to execute functions and set options and parameters.
/
/
/
)
) button moves the cursor to the left; the
RC-SREV1 Control Surface
) button moves it up; the down (
RC-SREV1—Owner's Manual
5
)
Werbung
Inhaltsverzeichnis
