Selecting Temperature; Temperature Settings; Cleaning And Care - Beurer HK 55 Easyfix Gebrauchsanleitung

The pull-out Velcro fastenings make it very easy to fasten to the body. The elastic ensures that the
heat is always positioned optimally.
3. Operation
3.1 Safety
This heating pad has a SAFETY SYSTEM. This electronic sensor technology prevents the entire
surface of the heating pad from overheating by automatically switching off in the event of a fault. If
the safety system switches off the heating pad automatically as a result of a fault, the indicator lamp
is no longer illuminated even when the heating pad is switched on. Please note that, after a fault has
occurred, the heating pad can no longer be used for safety reasons and must be sent to the service
address indicated.

3.2 Selecting temperature

The fastest way to heat up the heating pad is to first set the switch to the highest setting. A
lower setting can be selected later if required.
After switching on the heating pad, the setting starts flashing briefly, while the heating pad
conducts a self-test. Then the setting remains illuminated continuously.
We recommend the lowest temperature setting for extended use of the heating pad.

3.3 Temperature settings

Setting: 0 Off
1 Minimum heat
2 Medium heat
3 Maximum heat
3.4 Fast heating
These heating pads have a fast heating function which allows them to heat up quickly
within the first 10 minutes.
3.5 Automatic switch-off function
These heating pads have an automatic switchoff function which stops the heat supply
approx. 90 minutes after switching on the pad. The illuminated function display then
starts to flash. To operate the heating pad again, you must first set the switch to zero.
After about 5 seconds, it can be switched on again.
If the heating pad is no longer used after the timed switch-off, it should be switched off
(setting "0") or else unplugged from the mains.

4. Cleaning and Care

Before cleaning the pad, always unplug it from the mains. Smaller stains
can be removed using a cloth or moist sponge together with a little liquid
detergent for delicate fabrics if necessary. Do not use any cleaning agents
containing solvents on the appliance.
Please note that the heating pad should not be dry-cleaned, wrung out,
machine-dried, pressed or ironed.
Before washing, first remove the plug-in connection together with the switch from the heating pad.
Set the washing machine to a gentle washing cycle at 40°C.
For ecological reasons, we recommend that the heating pad is only washed together with other tex-
tiles. Use a washing powder or liquid for delicate fabrics and dose it according to the manufacturers
instructions.
Please note that excessive washing will wear out the heating pad. For this reason, the heating pad
should only be machine-washed a maximum of 10 times throughout its entire life.
9
90
min
STOP