Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DISPLAY
Standard indication:
Line-1:
Output power of both output channels. Amplifier calculated the output power.
NOTE:
Line-2:
If CLIP ON the amplifier input/output is overloaded. Reduce in that case the input level.
Line-3:
Protection information.
Line-4:
Tempeture of the output stage of both channels
Bargraph:
Vertical bargraph in the middle of LCD display indication the output signal level of both
channels
Indication for a few seconds after actuating a volume controller:
Line-1:
Operation mode STEREO, BRIDGE or PARALL
Line-2:
Limiter ON or OFF
Line-3 & 4: ATTEN, attenuation of the input signals, line 4 shows the level.
Bargraph:
Vertical bargraph in the middle of LCD display indication the output signal level of both
channels
Indication for a few seconds after selection the output impedance button (8):
Selected the correct output load for the calculation of the output power.
Select the correct load impedance (button 8)
Calculation not 100% correct in bridge operatio
6 - 32
Werbung
Inhaltsverzeichnis
