Operation - Daxten Voyager 60 Benutzerhandbuch

correctly for the length of interconnection cable used.
5. The 'GAIN' control is used to adjust the brightness of the overall picture. After
adjusting this control to suit, the 'EQ' control may need a very slight readjustment.
6. The picture quality can be improved additionally by adding a skew compensation
device to adjust for Cat5/Cat6 skew delay factors, i.e. variable twisted pair lengths
resulting from differing twist ratios (intended for decreasing crosstalk in digital
transmission contexts). Skew compensation devices are available from Daxten or
through your dealer.
Please note that for all practical purposes cable equalisation cannot be exact - the
remote image will never be as sharp as the original. The Voyager's equalisation system
is designed so that is produces very good results on short to medium length cables and
an acceptable quality over longer cables.
TIP: If you are at the top end of a cable length range, say 80m(260ft), and you are
using high resolution (1024x768 or more) you may achieve better quality video
compensation by selecting the next cable length range.

OPERATION

Keyboard & Mouse Emulation
The Voyager uses a microprocessor to emulate the keyboard and mouse. A keyboard
and mouse must be plugged into the remote unit at boot-up. It is not necessary to have
any keyboard or mouse connected to local unit either at start-up or during use.
Local / Remote Console Switching
The Voyager allows you to connect an additional keyboard, monitor, and mouse to
your system through the local unit. The PC may now be operated from either of two
locations though not simultaneously.
Pressing any key on the keyboard activates a console but the key press is ignored.
When the console is active, the other console cannot be operated. If the active console's
keyboard or mouse is not used for more than 2 seconds, console switching may occur.
All versions of the Voyager 125H/300 offer a Private Mode whereby the remote
console can be locked, preventing access from the other console. The Voyager 60 does
not have this feature. The commands work only from the local unit.
Mode 1: The remote unit is locked, preventing any access. (Voyager 125H/300 only)
Activate by pressing <CTRL><ALT><F10>
Mode 2: The remote monitor is active, but the keyboard and mouse are locked.
Activate by pressing <CTRL><ALT><F11>
These commands can be cancelled by pressing <CTRL><ALT><F12>
6
ENGLISH