Rockboard RBO POWER BLOCK Handbuch Seite 2

POWER BLOCK
Manual
Art. No.: RBO POWER BLOCK
RB Power Block Manual.indd 2
English
POWER SUPPLY DESCRIPTION & ACCESSORY
The ROCKBOARD POWER BLOCK • Simultaneous powering of 8 x 9 Volt
comes with a regulated 18 V power and 2 x 18 Volt pedals without loss of
adaptor, that can handle up to 2000 signal quality.
mA. It is built to handle 100 to 240 V
• 8 red LEDs indicate short-circuitry
input at 47 to 63 Hz.
for each 9V-port individually.
CAUTION: • Accessories: AC-Adaptor, connection
cables for each port.
If you use a proprietary power adaptor,
make sure it meets the above men-
tioned input and output data to avoid
overheating and damage of the unit.
18 Volt input jack; plug in DC power
adapter here
9 Volt output jacks with individual LEDs
indicating that short circuited pedals are
attached
Blue LED indicating if unit is powered
2 x 18 Volt output jacks for pedals with 18
Volt power supply
18V out 18V out
W a r w i c k G m b H & C o . M u s i c E q u i p m e n t
i n f o @ w a r w i c k . d e I s h o p . w a r w i c k . d e
CONNECTIONS & USAGE
1. Plug the included AC adaptor into the
units input port.
2. Plug the AC adaptor into the wall outlet.
The blue LED will light up to indicate
correct powering.
3. Connect your pedals to the appropriate
output ports with the included connec-
tion cables.
4. If one of the red LEDs lights up, a pedal
is short circuited. Refer to the wiring
diagram below to
5. connect the pedals with the correct
polarity. Power handling: 1500 mA in
sum for the eight 9 V outputs and 800
mA in sum for the two 18 V outputs.
Total Power handling: 2000 mA
- +
Use standard industry 5.5 x 2.1 mm jacks
with positive barrel and negative tip wiring.
K G , 0 8 2 5 8 M a r k n e u k i r c h e n / G e r m a n y
I w w w . f a c e b o o k . d e / w a r w i c k m u s i c d i s t r i b u t i o n
24.07.15 09:56