Application References; Assembly - HAVER & BOECKER W.S. Tyler Ro-TaP RX-29 Betriebsanleitung

2.2

Application references

The machine has been constructed according to the actual technical standards and the recognized safety
specifications. Although, there might be dangers for the user or third persons or impairments of the
machine and other goods.
Only use the machine in perfect technical constitution. Follow the operating instructions conscious of safety
and danger. Repair defects at once by authorized and qualified persons!
The machine has exclusively been developed for grain sieving to determine particle distribution. Any other
or further application is not as agreed upon. The manufacturer/supplier will assume no responsibility for
damages as a result of improper use. The risk is on the user's side.
For wet-sieving the RO-TAP needs a special "wet-kit"! Costs and information about this
additional equipment upon request.
3.

Assembly

Place the sound absorbing cupboard on a concrete foundation or a heavy, wooden work bench.
Install the RO-TAP to the middle of the cupboard. The rubber lining of the test sieve shaker foot prevents
the machine from gliding.
Connect the mains plug of the test sieve shaker with the socket (inside, at the back of the cupboard).
When installing the machine please take care that it is not accessible from downside. As the
RO-TAP is open at the bottom, there is a risk of injury.
If the machine is installed as described, there is no risk of injury.
© Copyright 2010 by HAVER & BOECKER Page 19/44