Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Wirless Audo Link
Instructions for Use
Control
Connecting MediaVision 3D to the Subwoofer
Coupling MediaVision 3D to the
Subwoofer
A system interface Wireless Audio-Link is integrated in your MediaVision 3D.
You can use this to connect your Loewe Subwoofer to MediaVision 3D without
any annoying cables. This connection must be setup once.
➠
The operation of Wireless Audio-Link requires a software version
for MediaVision3D of version V059 or higher. You can learn more
about updating the software on page 24 of the MediaVision3D
instructions for use.
➠
The operation of Wireless Audio-Link requires a Loewe Subwoofer
(from art. no. 69211T10/ U10/ W10) or Subwoofer Compact with
integrated or retrofitted Module Wireless Audio Link.
Move the Wireless switch to the ON position (Loewe
Subwoofer) or move the Mode - ON/AUTO switch to the
ON position (Loewe Subwoofer Compact).
Use the mains switch to switch the subwoofer to the
ON position.
Switch MediaVision3D on.
Call up the Main Menu.
Select the Settings option.
Select the Audio option.
Select the Wireless Speaker option.
Press OK to confirm.
Display
Language
Audio
Dolby PL II
Lock
Network
Others
Select the On option.
Press OK to confirm.
Use a sharp object (e.g. paperclip) to confirm within one
minute the Wireless Pairing (Loewe Subwoofer) button
or the button in the opening between the two switches
Mode Stereo and Auto (Loewe Subwoofer Compact).
The pairing takes up to 10 seconds.
A notification will appear if the pairing is successful.
A red message appears in the display of the MediaVision
3D when it is in Wireless Audio Link mode.
If the pairing is not successful, switch the units off
and on again after 30 seconds and repeat the above
procedure. Reduce the distance from the subwoofer to
MediaVision 3D.
- 3 -
- 3 -
Speaker Setup
:
:
:
:
:
:
Pairing of Wireless Speakers
:
:
:
Start pairing with OK. Then you have one mi-
nute to press pairing button at your subwoofer
to confi rm.
Cancel
OK
➠
Once it is successfully connected, turn each of the three knobs
on the Loewe Subwoofer by a quarter turn and specify the desired
settings for the equaliser, the bass intensity and the limiting
frequency. This initialises the correct values to wirelessly operate
the amplifier.
➠
The distance between the subwoofer and audio source must not
exceed 10 m in the same room.
➠
If you wish to toggle between the operating modes Wireless or
Cable via Audio-Link, switch the units off for minimum 30 seconds
and then on again.
➠
The rotary knobs Crossover Frequency, Equalizer and Bass Inten-
sity at the Subwoofer Compact do not have any function in Wireless
operating mode. In the Menu of MediaVision 3D you can adjust
the sound settings.
Werbung
