Technics SU-R1 Bedienungsanleitung Seite 12

AC mains lead connection
Connect only after all other connections are completed.
This unit
(rear)
∫ To disconnect the AC mains lead from this unit
Pull out the AC mains lead while pressing the top and bottom sides of the connector.
≥ Although the AC power switch is in the [
main electrical outlet if you will not be using the unit for an extended period of time. Place the unit so the plug can be easily removed.
NORSK
≥ Selv om hovedbryteren er i stilling [
enheten på en stund. Plasser enheten slik at det er lett å dra ut kontakten.
Measuring the characteristics of the amplifier and correcting its
output
If the SE-R1 is connected to this unit via the system control function, you can operate using the remote control of this unit.
Press and hold [LAPC] until the LAPC indicator on the SE-R1 starts to blink.
≥ The SE-R1 will start measuring the characteristics of the amplifier if it is connected to the speakers.
≥ For information on the operations of the SE-R1, please also refer to its operating instructions.
12
(12)
DO
] position, the unit is not completely disconnected from the mains. Remove the plug from the
], er ikke enheten koblet fra strømnettet. Koble kontakten fra strømuttaket hvis du ikke skal bruke
TENTATIVE
DO NOT
To a household mains socket
AC mains lead
(supplied)


