Werbung
Verfügbare Sprachen
Verfügbare Sprachen
materials and care
synthetic wickerwork
The PE wickerwork used for our beach chairs is
weather- and UV-resistant, fully recyclable and
particularly easy to care. Clean only with water,
sponge and mild soap.
Please do not use cleaning agents
containing tensides.
Use of a special plastic cleaner is recommended in
case of heavier soiling.
Wooden parts
In order to protect against the effects of weather,
the wooden parts of our beach chairs are
impregnated with a commercially available wood
protection glaze. Renew the latter if necessary
depending on the degree of wear and seek advice
from the specialist dealer when
purchasing the glaze.
The beach chairs with a teak carcase do not need
treatment, since teakwood is highly weather-
resistant owing to its high natural
oil content. The teakwood exposed to weather
acquires a silver-grey patina over time; this can be
avoided from the outset by using teak
oil at an early stage. (Please only apply to clean and
dry wood.)
The beach chair should always be
protected against extreme weather
using a deVries protective hood.
Beach chairs are not waterproof. If it rains, either
use the cover or remove all pillows from the chair.
To prevent mould, air the chair regularly.
Please make sure the beach chair is stored dry
and ventilated in case not used for a longer period
(e.g. winter). In addition a terry towel might be
placed between the hood and the roof of the beach
chair – this reduces condensation water and avoids
deVries PUre Baltic XXL| hergestellt für /
© dekoVries Gmbh · Birkenstrasse 1-2 · 26847 Deternerlehe · Germany · www.deVries-Group.de
Strandkorbpflege
Beach chair care
mould spots.
Place four sturdy stones under the corners of the
beach chair in order to avoid water penetrating the
wood from below.
fixed upholstery and cushion equipment
The fixed seat and back upholstery is manufactured
from dimensionally stable foam with awning
materials. These materials are predominantly
impregnated and receive water-repellent
treatment.
However, over the course of time, the impregnation
wears off but can be restored again using an
impregnation spray. Minor stains can be removed
using a brush and mild soap solution or a special
awning cleaner. Stubborn stains (grease, fat etc.)
are best removed with common commercially
available special stain removers.
The removable cushion equipment and foot
upholstery are equipped with a zip and are
washable.
The cushion equipment should be removed
over winter time. Using cedar wood chips helps
protecting your beach chair from bugs - effective
and environment-friendly.
Produced for:
As far as weather conditions allows the
hood should be removed from time
to time and the beach chair should be
ventilated.
Following an intensive cleaning the
impregnation should always be renewed.
Please observe the indications on the
sewn-in textile label in case of cleaning.
Seite 5 / 8
Werbung
