Important Safeguards - Team HT 23 Gebrauchsanleitung

Fax +32 2 359 95 50

O P E R A T IN G IN S T R U C T IO N S
G B

IMPORTANT SAFEGUARDS


Please read these instructions carefully before using the appliance.

Check that your mains voltage corresponds to that stated on the appliance.

Never leave the appliance unsupervised when in use. Keep out of reach of children or
incompetent persons.

From time to time check the cord for damages. Never use the appliance if cord or appliance
show any signs of damage.

Only use the appliance for domestic purposes and in the way indicated in these instructions.

Never immerse the appliance in water or any other liquid for any reason whatsoever. Never
place it into the dishwasher.

Never use the appliance near hot surfaces.

Should the cord be damaged, it must be replaced by a competent qualified electrician

Before cleaning, always unplug the appliance from the power supply.

All repairs should be made by a competent qualified electrician

Never use the appliance outside and always place it in a dry environment.

To ensure a major security, it is recommended to set up a current flight jump 30 mA in the
electric circuit which supplies the bathroom.

Never use accessories which are not recommended by the producer. They could constitute a
danger to the user and risk to damage the appliance.

Never move the appliance by pulling the cord. Make sure the cord cannot get caught in any way.
Do not wind the cord around the appliance and do not bend it.

Never use the appliance in bath, shower or above a sink filled with water! However, should the
appliance happen to fall into the water :
- immediately unplug it
- do not put your hands into the water
- make sure your appliance is verified by a competent qualified electrician
using it again.

When using the hairdryer in the bathroom, always unplug it when not in use, as the proximity of
water could constitute a danger even when the hairdryer is switched off.
Always make sure your appliance is not wet (water splashes,...) and never handle it with wet

hands.

Unplug the appliance when not in use or even if you put it down only for a moment

Inevitably the air intake grille becomes hot when using the appliance. Make sure the cord does
not come into contact with the air intake grille when using the appliance

The air intake and outgoing openings must never be blocked. However should the air ventilation
get blocked, the safety device will stop the appliance immediately. The latter will restart when it
has cooled down. You will have to wait a couple of minutes.

The safety grille in the air intake opening prevents the hairs from being sucked in. If you notice
after some time that the grille gets blocked by dust, you have to clean it. If you don't clean it, the
air flux will progressively decrease and the appliance might get damaged.

Make sure the hair does not come into direct contact with the air intake opening.

If your appliance can function with 2 voltages (visible by a small 2-position switch graded to the
2 most frequent voltages), you have to verify that the tension switch is set to the position that
corresponds with the voltage of your region). Otherwise the appliance might suffer serious
damages which will not be covered by the guarantee.
Generated by Unregistered Batch DOC TO PDF Converter
2011.3.804.1511, please register!
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International
BELGIUM. The page must reproduced and folded in order to
obtain a mini booklet B5 (+/- 150 mm width x 210 mm height).
The page must be folded in order to keep the good numbering
when you turn the page of the I/B . Don't change the page
numbering. Keep the languages integrity.
Assembly page 9/28
(*)
.
9
(*)
.
(*)
before