Overview Of The Components - BOMANN HL 1120 CB Bedienungsanleitung

• The radiator should not be placed directly below a mains power
socket.
• Do not try to repair the appliance on your own. Always contact an
authorized technician. If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.

Overview of the Components

1 Handle
2 Function control knob
2a = Off
2b = Fan
2c = 1000 Watt
2d = 2000 Watt
3 Function indicator lamp
4 Temperature control
5 Knurled screws
6 Stand
7 Protective grille
Notes on use
Unpacking the appliance
1. Remove the appliance from its packaging.
2. Remove all packaging material such as foils, padding,
cable holders and cardboard.
3. Fully unwind the cable.
NOTE:
There might be dust and production residue present on the
appliance. We recommend cleaning the device as described
under "Cleaning".
Position
CAUTION:
The appliance may tip over onto its front, blocking the air
flow.
Always set the appliance onto the stand. The ideal position is a
non-slip, flat surface.
Electric connection
1. Make sure the voltage of the appliance (see rating label)
matches the mains voltage to be used.
2. Set the control knob to .
3. Connect the mains plug to a properly installed isolated
ground socket.
HL1120CB_IM
Connected load
The appliance supports a power input of 2000 W.
CAUTION: Overload:
• When using an extension cord, it must have a cable
cross-section of at least 1.5 mm².
• Do not use multi-outlet power strips, since this appliance
is too powerful.
• Do not connect any other powerful devices to the same
electric circuit.
Operation
Setting the temperature
The thermostat constantly switches the radiator on and off,
thereby keeping the temperature at the desired level. Set the
desired temperature as followed:
1. Set the temperature control to its highest setting.
2. Once the desired temperature has been reached, slowly
turn the temperature control back, until the radiator switch-
es off audibly. The indicator lamp turns off.
NOTE:
The audible position of the temperature control depends
on the ambient temperature.
3. The radiator will then keep the desired temperature level.
CAUTION:
When not using the appliance, disconnect the mains plug.
Adjusting the inclination angle
Do you want to change the inclination angle?
Proceed as follows:
1. Loosen the knurled screws slightly by turning them counter-
clockwise, so that you can move the housing.
NOTE:
Only loosen the knurled screws. Otherwise the housing
will fall off the stand.
2. Swivel the housing to the desired position.
3. Fix the housing by tightening the knurled screws again.
27
07.04.16