Operation; Cleaning And Care - Team VT 18 Gebrauchsanleitung

Fax +32 2 359 95 50

ASSEMBLY
A. Base
The upper and lower part of the base must be fitted together before using the fan.
Insert the upper part (8) into the lower part (9) of the base, then press the upper part of the
base onto the lower part of the base till it clicks. Fix the two parts together with the 3 screws
provided. Do not over-tighten these screws.
B. Guards
1. Loosen the cap (2) from the motor housing by rotating it clockwise.
2. Loosen the guard mounting ring (5) from the motor housing by rotating it anti-clockwise.
3. Position the rear guard (6) firmly against the motor housing and fasten by turning the
guard mounting ring (5) clockwise tightly.
4. Remove and discard the PVC sleeve on the motor shaft.
5. Place the blade (3) along the motor shaft, locating the slot at the back of the blade on
the drive pin that passes through the motor shaft.
6. Fasten it firmly with the cap (2) by turning anti-clockwise.
7. Fit the front guard (1) and the rear guard (6) together with the clips provided. Attach the
front guard (1) to the rear guard (5) with the position fixer located on the front guard rim,
and then fit them together with the clips provided.
8. To ensure that it is impossible to have access to the fan blade without using a tool, a screw
is provided with this appliance in order to attach both parts of the mesh guard together.
This screw must be tightened on the lower part of the guards. We cannot be held
responsible for any injuries in case this screw had not been tightened before using the
appliance.

OPERATION

 This appliance is equipped with 3 ventilation speeds. To switch on the appliance, press
one of the speed knobs. To switch it off, press "0".
Speeds:
0 = OFF
1 = Low
2 = Medium
3 = High
 This appliance also has an oscillation function:
 Push the oscillation knob (7) to switch on the oscillation.
 Pull the oscillation knob (7) to stop.

CLEANING AND CARE

 Always disconnect the power supply cable from the power supply before carrying out any
cleaning operation.
 To remove dirt from the plastic surfaces, use a cloth moistened with a little water. Use a
vacuum cleaner to remove the dust from the guards without having to disassemble them.
 Never immerse the fan in water or any other liquid.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
8
Assembly page 8/28
TEAM VT 18 - 061125