Team EKP 9 Gebrauchsanleitung Seite 5

Fax +32 2 359 95 50

USE
 First check that the voltage marked on the product is the same as your supply voltage.
 Select a suitable position close to an electric socket, on a dry and even surface.
 Make sure the controls are in the OFF position (0 facing upwards). Plug in.
 The invisible protective coating must be removed before you can use the appliance. To
do this, set the controls to the maximum setting and leave switched on for approximately
10 minutes. Smoke will develop, make sure that the room is ventilated. Switch off the
cooking plate and allow to cool down completely. The cooking plate is now ready for
use.
 Always use flat-bottomed saucepans, which make good contact with the cooking plate.
The saucepan bases should ideally be of the same size as the cooking plate.
 Select the temperature. The cooking plate has a range of temperatures.
Due to the cooking plate‟s construction, residual heat will remain after switching off. This

may be used to keep food warm for a short period.
 After use, turn temperature dial to "0" and unplug iron from electrical outlet.
CLEANING
 Before cleaning, unplug and wait for the appliance to cool down.
 Wipe with a moistened cloth.
 Do not clean with any abrasive scouring pad or steel wool, as this will damage the finish.
 Do not immerse in water or any other liquid.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don‟t change the page numbering. Keep the
language integrity.
5
Assembly page 5/16