Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fax +32 2 359 95 50
INITIAL OPERATION
When you use your appliance for the first time, pour fresh water into the water tank (without
coffee) and switch on the appliance.
Once all the water has passed through, switch the appliance off and let it cool down. When it
is cold enough repeat the process with fresh water. Repeat this process 3 times.
PREPARATION OF COFFEE
Open the lid of the water tank.
Pour the desired amount of water into the water tank. Make sure not to overfill by
respecting the maximum level indicated on the water tank.
Insert a paper filter or permanent filter (depending on the model) in the filter holder and
add the desired quantity of ground coffee. Replace the filter holder, making sure it is
placed correctly.
Never forget to close the lid before switching on your coffee maker.
Switch on the coffee maker. The pilot light of the switch will be illuminated, indicating that
your appliance works. Thanks to the keep warm function, your coffee is warmed up as
long as the appliance is switched on. Note that the appliance will be switched on as long
as you do not switch it off manually. We advise you not to let the appliance switched on
more than 2 hours and make sure that you never let an empty jug on the appliance.
Wait until the brewing process is finished and the filter has run empty before removing the
jug.
DECALCIFICATION AND CLEANING
Decalcifying the coffee maker prolongs its life span. For decalcification only use products
especially made for decalcification of coffee makers.
Never use a dishwasher to clean the jug. Just clean it in soapsuds.
To clean the plastic parts of the appliance, use a humid, non abrasive cloth.
PRACTICAL HINTS
When you notice that the coffee making process is longer than it should be it is probably time
to decalcify the appliance. Do not wait until the situation gets worse. The decalcifying
frequency depends on the amount of lime in water and therefore can be different from family
to family. Therefore it is important to pay attention to this. Guarantee claims will not be
accepted for the replacement of a heating element full of scale.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
5
Assembly page 5/16
Werbung
Inhaltsverzeichnis
