Electric Installation - Clatronic BQS 3444 Bedienungsanleitung

Location of Controls
1 Wind deflector
2 Grid
3 Handle
4 Heating element with thermostat and temperature control
5 Indicator light
6 Reflector
7 Grill base
8 Stand support
9 Rack
10 Legs
Unpacking the device
1. Unpack the device.
2. Remove all packaging materials such as foils, filling material,
cable ties and cardboard packaging.
3. Check the scope of delivery.
NOTE:
There might be particles or production remains on the device. We
recommend you wipe the enclosure with a damp cloth.
Installation
You can assemble the grill as a standing grill using the stand or as a
table top device without the stand.
Refer to the left hand figure on page 3.
1. Remove the grid (2) and the heating element (4).
2. Remove all packaging materials.
Assembling the stand
3. Turn the grill base (7) on its head.
4. Insert the legs (10) with the open ends into the feet (8) of the grill
base so that the wing nuts face inwards.
5. Loosen the wing nuts from the legs. Leave the Philips head
screws in the holes in the legs.
6. Fit the holes on the rack (9) onto the Philips head screws thread.
7. Attach the rack to the legs using the wing nuts.
8. Place the device onto the stand.
9. Check whether all the legs are attached to the feet.
Stand or table top device
10. Clean the grid and the reflector (6) with a damp cloth.
11. Put the reflector plate into the grill base.
12. Pour 1.5 liters of cold water into the grill base, as to cover the
plate.
You will find a "MIN" / "MAX" marking inside the grill base on the
rear wall.
CAUTION:
Fill with water until above the reflector plate. The water bath
and the plate will prevent excessive radiated heat near the base
of the device. Therefore always barbecue using water and the
fitted reflector plate.
13. Attach the heating element with the thermostat (4) to the grill
base:
Using the recess, guide the thermostat horizontally onto the
grillbase. In doing so, tilt the heating element upwards slightly so
that the plate (B) rests in the grill base.
NOTE:
The thermostat is equipped with a safety switch (A). It prevents
the operation of the heating element outside of the grill base.
Check the correct fitting of the thermostat in the grill base.

Electric installation

1. Be sure the voltage of the device (rating plate) is in accordance
with the mains voltage.
2. Connect the mains plug to a properly installed shockproof socket
only.
Connected load
The device is intended for a maximum power intake of 2000 W. This
connected load recommends a separate input lead secured with a
16 amp protected switch.
CAUTION Overload:
• When using extension cords, these should have a cable cross-
section of at least 1.5 mm².
• Do not use gang plugs, because the device is too powerful.
Prior first-time operation
• Operate the device without barbecue for 15 minutes whilst grill
base is filled with water.
• Turn the temperature control on the thermostat to the highest
position.
• The protective foil on the heating element will be removed.
27