VXI VEHS-C1 Benutzerhandbuch

VXi Corporation | 271 Locust Street, Dover, NH 03820 USA
Toll Free | Sans frais | Número gratuito | Gebührenfrei: (800) 742-8588
Phone | Téléphone | Teléfono | Telefon: 1 603 742-2888
vxicorp.com
© 2016 VXi Corporation
All other trademarks are property of their respective owners | Toutes les autres marques commerciales
sont des marques de leurs propriétaires respectifs | Todas las demás marcas son propiedad de sus
respectivos dueños | Alle anderen Markenzeichen sind Eigentum der jeweiligen Inhaber
Printed in China | Imprimé en Chine | Impreso en China | Gedruckt in China
APN 203429C
INSTALLATION
1. Remove the panel from the bottom
of the base station. (Refer to the
VXi wireless headset user guide for
additional information).
2. Attach the VEHS-C1 to the bottom
of the base by carefully inserting the
plastic guide pin into the screw-hole
socket. Then press together the rear
of the base and VEHS-C1 until it snaps
into place.
3. Insert the color-coded cables from the
VEHS-C1 into the corresponding color-
coded jacks of the base station; the
connectors should 'snap' in place when
fully inserted.
TEL WALL
EHS/LIFTER POWER BASE JACK HANDSET
JACK
* This user guide describes the installation steps to connect the VEHS to your phone. For information about your phone's
capabilities or provisioning requirements go to www.vxicorp.com/resources/vehs, visit your phone system manufacturer's
website, or contact your IT administrator.
4. Connect the longer VEHS-C1 cable
into the AUX port of the phone (the
AUX port is generally located on the
bottom of the phone).
AUX
Additional Information for for V-Series
DECT Headsets
- Base station should be in MODE 2.
- 'Compatibility Switch' should be placed
in the 'A' position (refer to the headset
user guide for additional information).
- Connect one end of the base jack cord
(orange tag) into the base jack (orange
dot on base) and the other end into the
headset port of the telephone.
LED Status Indicator
The LED status indicator indicates the
phone's mode as shown by the table below.
Phone Mode LED indicator
On-hook Solid on
Off-hook Slow flash
Fast flash
Incoming ring detected