Mounting The Control Box; Tools Required; Connecting The Control Box - Waeco MagicWatch MW-SSC-01 Montage- Und Bedienungsanleitung

_MW-SSC-01.book Seite 17 Dienstag, 10. Oktober 2006 3:11 15
MagicWatch
6

Mounting the control box

6.1

Tools required

For installation and assembly you will require the following tools:
Drill bit set
Drill
Screwdriver
Set of ring or open-ended spanners
To make and test the electrical connection, the following tools are required:
Diode test lamp or Voltmeter
Insulating tape
Cable bushing sleeves, if necessary
To secure the cable you may require additional screws and cable binders.
6.2 Securing the control box
Take the length of the cable into consideration when selecting a location to mount the con-
trol box:
➤
Attach the control box to a suitable location in the vicinity of the dashboard (see 4,
page 4).
6.3

Connecting the control box

WAECO recommends that you should always connect the control box to the brake light
or the hand brake indicator light in all cases. This gives you the option of switching off the
control box using the brake selected if the corresponding operating mode has been set
(see the "Setting the operating mode" chapter on page 18). This means you can prevent
the parking aid giving out warning signals in traffic jams, for example.
When reversing, the control box is switched off via the yellow cable. This function can be
disabled by not connecting the yellow cable.
Use the connection diagram
7, page 5, if you connect the control box to the brake light,
8, page 6, if you connect the control box to the hand brake indicator light.
➤
Insert the plug of the connection cable into the socket of the control box
(5 1, page 4).
➤
Connect the red cable to the positive terminal (+) of the MagicWatch system.
➤ Connect the black cable to the earth terminal (–) of the MagicWatch system.
➤
Connect the white cable to earth (body work).
➤
Connect the blue cable to the signal wire of the speedometer.
➤
Connect the brown cable to the ignition.
Mounting the control box
17