The Front (Control) Panel; Standby Switch & Leds - Adam S3X-V Bedienungsanleitung

4.
4.1

The front (control) panel

On the front you will find a new, highly
sophisticated control panel that allows detailed
fine-tuning of your loudspeakers to your
particular room acoustics and personal listening
preferences. The following tips are intended
to assist you at using the controls in the best
manner.
Please note that using the controls
may have a great impact on the overall
sound characteristics of your loudspeakers. We
recommend using the controls with utmost care
and only after several audio tests with familiar
recordings.
4.2 Standby Switch & LEDs
The main power switch can be found on the rear of the
loudspeaker. On the front, there is switch for power on/standby.
In standby mode, the switch glows orange, in power on mode it
glows green.
Above the standby switch you find two LEDs:
• In case of an overload, the
protective curcuit will safe your speaker from damage.
• All SX-models from the S2X can be retrofitted with a 24 bit / 192 kHz
D/A Converter. The D/A LED glows blue when a converter is inserted in
the input on the rear side of the speaker.
Controlpanel/Speaker Adjustment
OL LED will flash red. A
Figure 4: Control panel
9