Set-Up - Clearaudio ACCU+ Bedienungsanleitung

ACCU+ Power Supply
User manual / Bedienungsanleitung

2. Set-up

ACCU+ Power Supply"
Before you can use the " , you have to insert the provided rechargable
"ACCU +"
accumulators into the - device.
To avoid a self-discharging the accumulators are not pre-installed before first set-up.
1. Remove the screw on the bottom side of the case with the provided hex-wrench.
Now pull the slide-in module carefully out of the case.
Please take special care of the connection cable during this step.
Now insert the provided accumulators in the intended mounting plates as shown below.
Please pay attention to the correct fit of the contacts, before you engage with light pressure
into the mount. Now push the slide in module carefully back into the housing and lock it with
the screw on the button side.
NOTE:
ACCU+ Power Supply"
When the " leaves our factory, the supplied,
rechargeable accumulators (NiMH-type) are fully charged.
Please keep in mind, that the capacity of the accumulators decreases,
when the unit is not in use for a few weeks.
To avoid self-discharging of the accumulators they are not inserted in
"ACCU+ Power Supply".
the
"ACCU+ Power Supply"
If your is not in use for longer than one (1)
week, please remove the rechargeable accumulators to avoid a total
discharge.
5  clearaudio electronic GmbH 2009