Werbung
User Manual
Initial Set Up
The WHF-45 can be used with either a standard analogue stereo audio input, or with a digital
input via USB.
Analogue Input
1. Insert 2 x AAA batteries into the headphone battery compartment.
2. Connect the Wireless Transmitter to your Audio source using the supplied 3.5mm to 3.5mm
audio cable. If your source uses a Phono Output then connect the Phono to 3.5mm Adapter,
to the source and then connect this to the 3.5mm to 3.5mm audio cable.
3. Connect the USB Cable to the USB Port on Transmitter and the other end to the USB Power
Supply.
4. Connect the USB Power Supply to an electrical socket and the Transmitter Power LED will
illuminate.
5. Slide the Input Selection Switch to Audio In.
6. Turn your TV or other AV source equipment on and set the volume to a low level.
7. Now switch on the Headphones using the power button on the left ear piece and you will
begin to hear audio.
8. The volume level can be adjusted using the volume rocker switch, also on the left ear piece.
Digital Input
1. Insert 2 x AAA batteries into the headphone battery compartment.
2. Connect the Wireless Transmitter to your Computer using the supplied USB A/Mini-B cable.
3. Slide the Input Selection Switch to USB.
4. Turn your Computer on and let the operating system install the required drievers
automatically.
5. Once installation is complete set the Audio Output of your computer to E-Core Wireless
Audio and then set the volume to a low level.
6. Now switch on the Headphones using the power button on the left ear piece and you will
begin to hear audio.
7. The volume level can be adjusted using the volume rocker switch, also on the left ear piece.
Operation
To power on the Transmitter or Headphones, simply press the corresponding Power Button
once.
To power off the Transmitter or Headphones simply press and hold the corresponding Power
Button for approximately 3 seconds.
If the Transmitter and headphones do not automatically connect, the Connect LED on the
Transmitter and the Power Button on the Headphones will flash. Press the Connect button on
the Headphones for approximately 5 seconds and you will start to hear a repeated beeping from
the headphones. Now press and hold the Connect Button on the Transmitter until you hear a
continuous tone from the headphones, then release the button. The Connect LED on the
Transmitter will briefly flash and then go solid blue to indicate the connection has been made.
3
English
Werbung
