Installing The Flight Battery; Troubleshooting Guide - XciteRC 13000000 Bedienungsanleitung

Installing the flight battery

• Put the throttle stick to the lowest position.
• Turn on the transmitter.
EN
• Install the flight battery in the battery holder, connect the battery with 4-in-1 main board, place the heli-
copter static level next to the transmitter.
• Waiting several seconds, the main rotor flap up and down twice, it means the heli successfully bind to the
transmitter. Please move the heli after the binding finished.

Troubleshooting guide

Problem
LED on 3-in-1 board flashes con-
stantly and operating no function
after connecting battery to heli
The helicopter do not response
after connecting batteries to
receiver
When push the throttle pole,the
rotor do not rotate and the LED
on Receiver flashes constantly.
Helicopter takes off immediately
once the batteries and helicopter
connected.
Turn on the helicopter after bind-
ing succasafully,the propeller ro-
tate constantly but the hellcoptar
can not take off.
Helicopter vibrates os shakes in
flight.
18
Possible cause
Transmitter is not bound to re-
ceiver
Check whether the transmit-
ter and helicopter connecting
to power; check the voltage of
transmitter and helicopter´s bat-
tery; battery pole flake contact is
not good.
Low battery voltage; batteries
connection is not good.
Didn´t put the throttle to the low-
est.
Low charge in aircraft batteries
or main gear loose.
Damaged rotor blades and lateral
axis blade grips too tight causing
the movement of the main rotor
isn´t smooth.
Getting started
Solution
Bind transmitter to receiver.
Open the transmitter, make sure
the batteries connecting is good;
replace and charge transmitter
batteries, make sure the battery
pole flake contact is good.
Replace and charge the
batteries,reconnect the batteries
to the receiver board.
Put the throttle pole at thel owest
position before open the trans-
mitter.
Replace and charge the batter-
ies ;press the spindle with gear
tightly.
Change the main rotor blades,
and lateral axis.; loosen the
bllade grips properly.
13000000 XciteRC Flybarless Trainer 200 13000000 XciteRC Flybarless Trainer 200