Setup Functions; Automatic On/Off Function (Aut); Consumer Electronics Control (Cec) - Canton Digital Movie 90.3 Bedienungsanleitung

English

Setup functions

Automatic ON/OFF function (AUT)

When this function is activated (ON) the device identifies a signal through the optical or coaxial input. When a signal is detected (e.g. by
switching on the source device) the DM system turns itself on. if no such signal is detected on the selected input (e.g. when the source
device has been switched off) the DM system will automatically go into Aut standby mode after 30 seconds. When the function is deacti-
vated (OFF) the DM system needs to be switched on and off manually.
the device is supplied with the function deactivated (OFF).
to activate/deactivate this function proceed with the following steps:
With the device switched on, press and hold the "Play Mode" key for more
1
than 3 seconds, until A U T appears on the display.
Press the "Volume +" key to activate the function (ON)
2
Press the "Volume –" key to deactivate the function (OFF).
3
exit the menu by again pressing and holding the "Play Mode" key for more
4
than 3 seconds. if no input has appeared within 10 seconds the device will
automatically exit the configuration menu.
Comment: the automatic switching on/off function only works for optical and coaxial digital input. if the device is set to standby mode
using the "ON/StANDBY" key on the remote control it is not possible for the device to switch on automatically.
the device only identifies a signal at the selected digital input. A signal that appears at any other than the selected digital input cannot be
detected.
50
ON ON MUTE MUTE
STANDBY STANDBY
STEREO STEREO BASS BASS
SURROUND SURROUND TREBLE TREBLE
tV remote control
BLUETOOTH
PAIRING

Consumer Electronics Control (CEC)

Consumer electronics Control (CeC) is a cross-market standardized protocol for controlling end devices connected to the HDMi
inputs/outputs. the device is supplied with this function deactivated (OFF).
the CeC functions supported by the DM system are:
- One touch Play: By pressing the "Play" key of the Blu-Ray player the DM system switches on automatically and changes to the
corresponding HDMi ® input.
- System Standby: With the tV switched on, when you return it to standby mode by pressing the "Power" key the DM system also goes
automatically into standby mode.
Note: Depending on the programming of the tV the DM system can also be automatically activated with the tV.
- Volume/Mute: the volume of the DM system can be controlled using the Mute and Volume keys on the tV remote control.
to activate/deactivate this function proceed with the following steps:
With the device switched on, press and hold the "Play Mode" key for more than 3 seconds, until
1
Press the "Play Mode" key again briefly, until appears on the display.
C E C
2
Press the "Volume +" key to activate the function (ON).
3
Press the "Volume –" key to deactivate the function (OFF).
4
exit the menu by again pressing and holding the "Play Mode" key for more than 3 seconds. if no input has appeared within 10 seconds
5
the device will automatically exit the configuration menu.
Comment: Many device manufacturers have developed their own protocols for controlling their devices based on the CeC standard. this
can mean that the functions described above only function partially, or do not function at all.
Warning: to avoid conflicts when controlling the DM system using the CeC function, the "Volume +/–", "Mute" and "Power" keys of the
tV remote control may not be learned by means of the iR learn function of the DM system. Please delete the iR codes on the DM system
where necessary (see page 57).
English
®
A U T appears on the display.
51