I) Select Language For Osd Menus (Function "Language"); J) Switch Usb Mode (Function "Usb Mode") - Imax IM0790 Bedienungsanleitung

i) Select Language for OSD Menus (Function "Language")

• In the main menu, select the function "Language" with the arrows and confirm your selection with "ENTER".
• Select the desired language for the OSD menus in the LC display with the arrow buttons and confirm your selection
with "ENTER".

j) Switch USB Mode (Function "USB Mode")

If the film scanner is connected to a computer, two different operating modes are possible.
1.The film scanner is supplied with power through a computer (e.g. if you do not wish to use the included mains
adapter)
2.The internal storage or any inserted memory card is logged on to the computer as a drive so that you can copy the
images onto the computer. In this operating mode, all other film scanner functions are deactivated.
Proceed as follows:
• In the main menu, select the function "USB MSDC" with the arrows and confirm your selection with "ENTER".
• The computer may recognise new hardware and then shows the content of the internal memory or an inserted
memory card.
• To terminate this operating mode, briefly press "MODE" once. The computer data connection is disconnected and
the film scanner functions can be used again.

If you have inserted a memory card in the film scanner, it can of course be removed for reading / copying
and inserted into a different card reader.
29