The Front (Control) Panel; Standby Switch & Leds - Adam Equipment S3X-H Bedienungsanleitung

4.
4.1

The front (control) panel

On the front you will find a new, highly sophisticated control panel that
allows detailed fine-tuning of your loudspeakers to your particular room
acoustics and personal listening preferences. The following tips are
intended to assist you at using the controls in the best manner.
Please note that using the controls may have a great impact on the overall
sound characteristics of your loudspeakers. We recommend using the
controls with utmost care and only after several audio tests with familiar
recordings.
4.2 Standby Switch & LEDs
The main power switch can be found on the rear of the
loudspeaker. On the front, there is switch for power on/
standby. In standby mode, the switch glows orange, in power
on mode it glows green.
To the right of the standby switch you find two LEDs:
• In case of an overload, the
protective curcuit will safe your speaker from damage.
• All SX-models from the S2X can be retrofitted with a 24 bit / 192 kHz
D/A Converter. The D/A LED glows blue when a converter is inserted in
the input on the rear side of the speaker.
Controlpanel/Speaker Adjustment
Figure 4: Control panel
OL LED will flash red. A
9