ECG BD 33 Bedienungsanleitung Seite 24

OPERATING INSTRUCTIONS
Before using the product for the fi rst time, remove all packaging material and place the device away from
children to ensure their safety against potential suff ocation or inhalation.
1. Open the container and fi ll with the required liquid soap or gel disinfection up to the MAX line, close the
container. Do not overfi ll the container, this may lead to spontaneous dripping.
Note: Cleaning agents may also be used as fi lling. Its density, however, is lower meaning the device will
release after 3-4 hand movements by the detection sensor (you will always hear the dispenser
motor running but no liquid being released). This cycle is repeated when the device is not used for a
longer period of time. After the fi rst dose, repeated doses will be carried out normally, for each hand
movement by the detection sensor. We recommend setting the dose level to medium or large.
2. Press the cover safety (OPEN) on the back side of the device, open the battery cover and insert 3× AA
batteries with proper polarity +/-, then close the cover.
If the batteries are dead, the LED indicator will begin fl ashing red after every dose for 10 seconds –
replace the batteries.
3. After opening the cover, use the buttons on the bottom side of the device to set the dispensed amount.
OFF – dispensing disabled
1 – small dose
2 – medium dose
3 – large dose
After the dispensed amount is set, the red LED indicator is lit for 12 seconds. This period is designated
for closing the cover and placing the device to its position, the device does not allow the activation of
dispensing during this period.
4. Place the magnetic part of the removable drip tray towards the device under the detection sensor.
5. Place hands under nozzle. Thanks to the detection sensor, the dispenser will provide the dispensed
amount set.
CAUTION!
Set the dispenser to "OFF" before refi lling, cleaning or changing batteries.
Cleaning mode
This function is used to remove the liquid from the device, whether to replace the liquid or to clean the
container.
1. Open the battery cover on the bottom side of the device.
2. Press the CLEAN button and the machine switches to automatic cleaning mode.
3. The red LED indicator is lit for 12 seconds. Close the battery cover during this period. The device will then
dispense liquid for a period of 30 seconds.
4. Press the CLEAN button to repeat the function.
Note: The dispensed amount shall not be set to OFF during the cleaning function.
5. Repeat the process until the container is emptied.
6. For best results, repeat the cleaning cycle by adding water to the container.
BATTERIES
EN
1. Only use the designated batteries that best suit this device.
2. Always replace dead batteries at once.
3. Wipe the battery contacts and the device contacts before inserting new batteries.
4. Ensure the battery polarities are correct (+ and -).
5. Remove batteries from the device if you do not plan to use the device for a longer period of time.
6. Immediately remove and dispose of dead batteries.
24