Operating Determinations; Approval - Omnitronic AB-1000 Bedienungsanleitung

Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will
not accept liability for any resulting defects or problems.
Keep away from heaters and other heating sources!
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
Please note that damages caused by manual modifications on the device or unauthorized operation by
unqualified persons are not subject to warranty.
Keep away children and amateurs!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.

3. OPERATING DETERMINATIONS

This device is an antenna booster for boosting antenna-signals. This product is allowed to be operated with a
direct current of 12-18 V and was designed for indoor use only.
In order to receive the signals, you need a hand-held microphone or pocket-transmitter with the suitable
carrier frequency.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
Do not operate the device in extremely hot (more than 30° C) or extremely cold (less than 5° C)
surroundings. Keep away from direct insulation (particularly in cars) and heaters.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers.

3.1 Approval

This wireless microphone system was tested in accordance with the European standards EN 300422-2, EN
301489-09 and EN 60065. Consequently, this product adheres to the R&TTE-Directive of the European
Union and does not need an individual EC type examination of every member state.
In some countries, the operation of this wireless microphone system needs to be approved by your telecoms
regulatory authority. Please refer to your authority as listed below:
Telecoms & Postal Regulatory Authorities in Europe
Austria Rundfunk und Telekom Regulierungs-GmbH
www.rtr.at
Belgium Belgian Institute of postal services and telecommunications (BIPT)
8/11 13063030_V_1_0.DOC