AEG PDU 10-2 Betriebsanleitung Seite 24

For reasons of personal protection, the product
must
exclusively on earthed power systems!
The power distribution unit is only allowed to be operated and
connected using the attached mains connection cable with PE
conductor on 220 / 230 / 240 V AC circuits with protective
earthing.
Observe the following safety instructions to
ensure permanent operational safety of and safe
work with the power distribution unit:
Do not dismantle the power distribution unit!
(The power distribution unit does not contain any parts
that require regular maintenance. Bear in mind also that
the warranty will be invalidated if the unit is opened!)
The product is designed to be installed inside in rooms.
Never install the power distribution unit in the vicinity of
water or in an excessively damp environment!
Condensation may occur if the power distribution unit is
brought from a cold environment into the room where it
is to be installed. The power distribution unit must be
absolutely dry prior to start-up. As a result, leave it to
acclimatize for at least two hours.
If the product is used in conjunction with a UPS
(uninterruptible power supply) as an additional output
distribution system, take care that the input of the UPS
is never connected to its output!
Ensure that no fluids or foreign bodies can penetrate
the power distribution unit!
The mains connection should be near the product and
easily accessible to facilitate disconnecting the AC input
or pulling out the plug!
be correctly
24
earthed, i.e. operated