Maintenance And Service; Maintenance And Cleaning - Bosch GML 24 VCD Bedienungsanleitung

1 609 929 J80.book Seite 9 Montag, 27. März 2006 3:27 15
Fault Finding and Troubleshooting
Problem Possible Cause
Radio or CD player Mains plug not plugged in.
not operative.
For battery operation: Battery not fully
inserted.
For battery operation: Battery dis-
charged.
Insufficient radio Bad location.
reception.
Aerial not aligned optimally.
12 V connection not Fuse for 12 V connection not inserted. Insert a 5 x 20 mm 1 A fuse.
operative.
Fuse for 12 V connection defective.
Power outlets 43 not Mains plug not plugged in.
operative.
Radio charger does not Mains plug not plugged in.
operate.
Software error.
Faulty clock display. Clock batteries dead.

Maintenance and Service

Maintenance and Cleaning

Before any work on the radio charger, pull the
mains plug from the power outlet.
If the radio charger should fail despite the care
taken in manufacturing and testing procedures,
repair should be carried out by an after-sales serv-
ice centre for Bosch power tools
In all correspondence and spare parts orders,
please always include the 10-digit article number
on the type plate of the radio charger. The type
plate is located on the bottom side of the radio
charger.
Mains Cable
The mains cable is fitted with a special safety con-
nection. The mains cable may only be replaced by
an authorised after-sales service agent for Bosch
power tools.
1 609 929 J80 • 06.03
Corrective Measure
Plug in the mains plug.
Completely insert the battery.
Charge the battery by plugging in
the mains plug.
Place the radio charger at a different
location.
Turn the aerial to other directions.
Replace the fuse.
Plug in the mains plug.
Plug in the mains plug.
If the display is not lit up when switched
on, the software in the radio charger
must be reset. Pull the mains plug
and/or remove the battery and wait for
30 seconds.
Replace the AAA batteries and reset
the clock.
WARNING! This appliance must be earthed.
Important instructions for connecting a new
3-pin plug.
The wires in the cable are coloured according to
the following code:
strain relief
live = brown
earth = green/yellow
Do not connect the blue or brown wire to the earth
terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this machine, it must be
disposed of safely.
English–9
To be fitted
by a qualified
professional only
neutral = blue