JGC NR 200 Bedienungsanleitung Seite 11

Tuning
Press button to select the frequency
BAND
•
band.
Press and hold the
•
to next available station with good enough
signal.
Momentarily press
•
manually tune to the desired frequency.
and button to scan
and button to
You can select the desired station by entering
the direct frequency on the numeric keypad.
Choose the band (AM or FM) by
•
then press (in AM mode) or
AM
mode), frequency reading will disappear.
Enter the frequency with the numeric keypad
•
and press (in AM mode) or
AM
mode) to confirm.
The selected frequency must be within the
•
frequency range for AM or FM band, otherwise
the display will show ERR
Valid frequency ranges:
FM: 87,5 - 108,0 MHz
AM: 522 - 1620 kHz
button,
BAND
(in FM
FM
(in FM
FM
11