Operating The Device - PENTAGRAM P3210 Bedienungsanleitung

If the pairing failed, the headset will switch into ready mode – perform the pairing again.
•
When pairing, the recommended distance between the headset and the paired device should
•
be between 0,3 ft (10 cm) and 3,2 ft (1 m).
When pairing the headset with another Bluetooth device, enter "0000" as the headset
•
password. In case of problems, consult the device manual.
The pairing is maintained even after one of the paired devices is switched off, the Bluetooth
•
module in a device is switched off and after one of the paired devices is switched on again.
Putting the headset on
Depending on your personal preferences, the headset may be adjusted to the right or the left ear.

Operating the device

Answering calls
1. When there is an incoming call, wait until you can hear the ring in the headset loudspeaker
and press the function key to answer the call.
2. If the phone starts ringing first, wait until you can hear the ring in the headset loudspeaker
and only then press the function key to answer the call.
3. When answering calls, the headset diode blinks blue four times per second.
4. If the phone starts ringing and the headset is off, first switch the headset on and then press
the function key to answer the call.
Depending on the manufacturer and the mobile phone model, the ring sound in the headset
loudspeaker may be different from or the same as the sound set in the phone.
Rejecting calls
To reject an incoming call, wait until you can hear the ring in the headset loudspeaker, then press and
hold the function key for 2-3 seconds and depress it after hearing a single sound.
Ending calls
When you have finished the conversation, press the function key to end the call.
•
Wait until the other side ends the call.
•
PENTAGRAM Bluetooth Headset (P3210)
left ear right ear
EN - 4