Klipsch iGroove HG Handbuch Seite 3

SYSTEM SETUP
Unpack the entire contents of the box. Place the
iGroove HG on a sturdy surface. Select the appro-
priate plug adapter for your outlet and connect it
to the power supply. Plug the power cord into the
rear of the iGroove HG. Plug the power supply into
a standard wall outlet.
The iGroove is intelligently designed to easily ac-
commodate all iPods. To configure the iGroove for
your specific iPod size, simply adjust the movable
back-rest, as shown below, to the proper location
based on the size of your iPod.
Over time, it may become necessary to tighten the
moveable back rest. To do this, remove the rubber
pad and tighten the screw as shown below. Re-
place the rubber pad after the screw is tightened.
SYSTEM OPERATION
THE DOCK
Your iGroove system is ready to perform as soon
as you plug it in and dock an iPod. The Power but-
ton located on the right of the iGroove will light up
"Red" in "Standby/Off" mode and "Green" in "On"
mode. The buttons on the left of the iGroove are
volume up and down.
Note: When the iPod is docked and the head-
phone mini-jack on the iPod is used, sound will
come from the heaphones as well as the iGroove.
The iPod's volume will control the headphone level
only. The iPod's volume will have no effect on the
volume of the iGroove.
THE REMOTE
The wireless remote control allows interaction with
the iGroove as well as the iPod.
Note: This remote must be pointed at the iGroove
in order to guarantee proper interaction.
• Power – Press to turn the iGroove "On"; press
again to put the iGroove in "Standby/Off."
• Play/Pause – Press once to "Pause" play; press
again to resume play. Press and hold to turn the
iPod "Off" (the iPod will continue to charge).
• Track Selection – Press 9 and  to move
to the previous or next track; press and hold to
reverse or fast-forward through the current track.
• Volume – Press + or – to decrease or increase
the system volume level.
Power
Play/Pause
Back
Volume Down
Mute
Forward
Volume Up
VOLUME